简体中文ENGLISH
Gear rack actuator
Screw hydraulic actuator
Electro-hydraulic actuator
Actuator accessories
Sequence valve
Filter
Flow regulator
Overcenter valves
Cartridge valves
Hand pump
Pilot hydraulic check valves
Rotary valves
One -way valve
Company news
Industry news
04-24
Valve driven hydraulic actuator - two structural configurations
The valve hydraulic actuator is powered by high-pressure oil and has the characteristics of large load capacity and high regulation. According to its structure, it can be roughly divided into two types: traditional separated type and intelligent integrated type.
Valve driven actuator - rack and pinion hydraulic actuator
The hydraulic actuator is powered by high-pressure oil and has the characteristics of large load capacity and high adjustment accuracy. The hydraulic actuator structure includes a blade type structure and a piston type structure. The blade type is divided into single blade type and multi blade type; The piston type includes subdivided gear and rack type, spiral piston, chain type, crank connecting rod type, and multiple actuators. This article briefly discusses gear and rack actuators. The following figure shows a typical gear rack structure actuator.
Valve driven hydraulic actuator - Selection considerations 1
The size of the swing angle determines the parameters during design. That is to say, the maximum swing angle of a selected manufacturer or structural actuator has been determined. So it mainly depends on whether the maximum swing angle can meet the application requirements. For example, if the full open angle of a butterfly valve is 90 degrees, choosing an actuator with a maximum angle of 94 degrees can basically meet its requirements
Valve driven hydraulic actuator - Selection considerations 2
The starting pressure and internal leakage of the actuator are related to the sealing quality of the moving parts. The sealing quality is also related to the mechanical processing quality, size, and sealing structure selection of the inner surface of the oil cylinder. Overall, if the seal is tight and there is less internal leakage, the friction force will increase and the starting force will increase; On the contrary, if the seal is loose, the internal leakage is large, the friction force is small, and the starting force is reduced.
Valve driven hydraulic actuator - Selection considerations 3
More and more automation controls require precise opening or positioning of valves, resulting in an increasing number of occasions where valve actuators are required to accurately position and control valve speed and position. This involves control when the actuator runs near the target area.
Power pack for valve driven electro-hydraulic integrated actuators
The rack and pinion intelligent integrated hydraulic actuator includes a rack and pinion actuator and power unit, a controller, valve position indicator, and position detection sensor. The overall seal is installed on the top of the valve actuator, except for the actuator. The overall structure is compact, sealed, dustproof, waterproof, and without pipeline connection.